586 electronic components fixing glue

First, the product features:
JXin586 is a paste-like one-component room-temperature curing silicone rubber. It is non-corrosive to most metals and plastics and has good adhesion. It has excellent resistance to cold and heat, aging and electrical insulation. Excellent moisture, water, shock, corona and leakage resistance. Fully in line with EU ROHS directive requirements.

Second, the typical use:
1. Dampproof and waterproof packaging of delicate electronic components
2. Packaging and molding of the parts to be bonded
3. Insulation and fixing seals for electronic components
4. Adhesive sealing of automobile headlights and energy-saving lamps
5, glass, metal, plastic bonding and sealing
6, refrigerators, microwave ovens, circuit boards, electronic components, solar energy bonding seals and mechanical bonding seals.

Fourth, the use of technology:
1. Clean the surface: clean the surface of the object to be glued or coated, and remove rust, dust and oil.
2. Apply glue: Unscrew (or cut open) the rubber cap, squeeze the glue onto the cleaned surface, make it evenly distributed, and fix the adhesive surface.
3. Curing: Place the glued or sealed parts in the air to allow them to cure naturally. The curing process is a curing process from the surface to the inside. Within 24 hours (room temperature and 55% relative humidity), the glue will cure to a depth of 2 to 4 mm. If the application position is deep, especially in areas where air is not easily accessible, The time for complete curing will be extended. If the temperature is lower, the curing time will be extended. It takes more than 7 days for the 6mm thick sealant to fully cure.
Five, note:
 1. After the operation is completed, the unused glue should be tightened immediately and sealed. When using it again, if there is a little crust at the seal, remove it and it will not affect the normal use. During the storage process, there may be a small amount of solidification in the mouth of the tube. After it is removed, it can be used normally without affecting product performance.

Sixth, packaging specifications:
100ml / support, 100 / box; 300ml / support, 24 / box.
7. Storage and transportation:
1. This product should be stored in a cool and dry environment below 25 °C. The storage period is below 6 °C for 6 months.
2, such products are non-dangerous goods, can be transported as general chemicals, careful to leak during transportation!
3. Products that exceed the shelf life should be confirmed before use.